Vidonn F1 - LED Indicator Status; Headphone Reset Procedure; Storage and Maintenance Guidelines

Enter into pairing mode
Press and hold the volume up
button until the LED flashes
red and blue alternately
Pairing
Turn down the volume
Click the volume down button
to adjust volume
There is one beep if reach
minimum
LED indicator
Status
LED display status
Charging
Solid red
Charging complete
Solid blue
Power on
Flash blue once
Power off
Flash red once
Pairing mode
Flash red and blue
Pairing complete
flash blue slowly
Unpaired
Flash red slowly
Playing music
Breathing blue
Incoming call
Solid blue
Low battery
Flash red slowly
How to reset your headphones
Enter pairing mode, then press multifunction button and both volume up button
simultaneously for 3 seconds.
Storage and maintenance
◆ Storage the headphones in cool and dry place, the working temperature should be 0-45℃
（32-113℉）. Working in cold/hot environment or highly humid area may reduce the life of
battery.
◆ After storage for a long time period, please charge the headphones before using again.
◆ The headphones are water resistant, but are NOT waterproof, please DO NOT submerse
the headphone in water.
◆ Listening with headphones at high volume may affect your hearing and the audio will be
distorted.
◆ Clean the headphone with a soft and dry cloth.
◆ Do not charge right after exercising, in case there is sweat inside the charging port, which
could lead to circuit burning while charging, keep the charging port dry before connecting
to charger will reduce the risk.