Viessmann Vitobloc 200 EM-260/390 User Manual

6130329 GB 04/2019 To be kept carefully!
Operating instructions
for specialists
VITOBLOC 200
block-type thermal power plant module for natural gas operation
model EM-50/81 model EM-199/263 model EM-401/549
model EM-70/115 model EM-238/363 model EM-530/660
model EM-140/207 model EM-260/390

Viessmann Vitobloc 200 EM-260/390 Specifications

General

Brand	Viessmann
Model	Vitobloc 200 EM-260/390
Category	Portable Generator
Language	English

Summary

Legal notice

Important general instructions for application

Key safety and usage guidelines for the equipment.

Instructions for operating the CHP

Qualification of the personnel

Requirements for authorized and trained operators.

Hazard warnings pursuant to the Machinery Directive

Potential risks during operation and maintenance.

Residual dangers from operating a combined heat and power plant

Analysis of residual risks during operation.

Requirements concerning the technical room

Safety and environmental conditions for the installation site.

Regulations for the prevention of accidents causing personal injury

Safety rules to prevent injuries during installation and operation.

Preparations

Natural gas, the fuel

Properties and regulations for natural gas as fuel.

Engine lubrication oil

Coolants

Heating water

Commissioning

Authorized personnel

Measuring and setting points for the commissioning

Identification of measurement and setting points.

Measuring and setting points on the module's control panel

Measuring and setting points at the CHP module

Commissioning instructions for the CHP module

Step-by-step guide for commissioning the CHP module.

Programming

Operator's and indicator unit of the CHP module

CHP module control level 1: Display & change operating values

Accessing and modifying operating values at Level 1.

CHP module control level 2: Manual mode

Operating the module in manual mode at Level 2.

CHP module control level 3: Display & change of parameters

Accessing and modifying parameters at Level 3.

Usage and operations

Duties of the plant operator

Requirements for optimal operation

Emergency

Procedures for central emergency stop and handling gas leaks or fires.

Trouble-shooting

Fault messages from the CHP module that cannot be acknowledged

List of fault messages and their potential causes.

Shutdown

Temporary shutdown

Final shutdown (decommissioning)