40
Emissions test mode should only be activated by your
flue gas inspector during the annual inspection.
Emissions test mode is enabled for flue gas measure-
ment with temporarily increased boiler water tempera-
ture.
The following functions are activated:
■
The burner is switched on. "Test in progress"
appears on the display
■
The pumps are started.
■
The mixers remain set to the control function.
■
The burner is switched off when the maximum tem-
perature set at the control unit is reached.
Note
Ensure that enough heat is being drawn during emis-
sions test mode.
Activating emissions test mode
Tap the following on-screen buttons:
1. If required, for the home screen
2. for the "Main menu"
3. "Test mode"
4. to confirm
Ending emissions test mode
You have 2 options for ending emissions test mode:
■
Tap .
or
■
Emissions test mode ends automatically after
60 minutes.
Emissions test mode
Emissions test mode
5863758
To Next Page
Loading...
