2
Please follow these safety instructions closely to
prevent accidents and material losses.
Safety instructions explained
Danger
This symbol warns against the risk of injury.
!
Please note
This symbol warns against the risk of material
losses and environmental pollution.
Note
Details identified by the word "Note" contain additional
information.
Target group
These instructions are exclusively intended for quali-
fied contractors.
■
Work on electrical equipment may only be carried
out by a qualified electrician.
■
The system must be commissioned by the system
installer or a qualified person authorised by the
installer.
Regulations to be observed
■
National installation regulations
■
Statutory regulations for the prevention of accidents
■
Statutory regulations for environmental protection
■
Codes of practice of the relevant trade associations
■
All relevant safety regulations as defined by DIN, EN,
DGW, VDE and locally applicable standards
a
ÖNORM, EN and ÖVE
c
SEV, SUVA, SVTI, SWKI and SVGW
Working on the system
■
Isolate the system from the power supply (e.g. at a
separate MCB/fuse or a mains isolator) and check
that it is no longer 'live'.
Note
In addition to the control circuit there may be several
power circuits.
Danger
Contact with live components can result in
severe injuries. Some components on PCBs
remain live even after the power supply has
been switched off.
Prior to removing covers from the appliances,
wait at least 4 minutes until the voltage has
completely dropped out.
■
Safeguard the system against reconnection.
!
Please note
Electronic assemblies can be damaged by elec-
trostatic discharge.
Prior to commencing any work, touch earthed
objects such as heating or water pipes to dis-
charge static loads.
Repair work
!
Please note
Repairing components that fulfil a safety func-
tion can compromise the safe operation of the
system.
Replace faulty components only with genuine
Viessmann spare parts.
Safety instructions
Safety instructions
5831646
To Next Page
Loading...
