Version: 8.0
14.09.2017
[
EN ● 6
]
INSTALLATION
5. Mount the panel onto the 4 screws
DISPOSAL
Do not dispose this product as unsorted municipal waste.
Separate collection of electrical waste is necessary.
1. Spread the drilling template to
cover the panel back, use a
pencil to mark the holes of the
hooks.
2. Use some double-side adhesive
tape to x the paper onto the wall
or ceiling. Then drill the holes.
3. Put the expansion tubes into the
holes.
4. Insert screws into the expansion
tubes.
panel
drilling
template
To Next Page
Loading...