Need help?Do you have a question about the Viewpro Falcon F390 and is the answer not in the manual?
General safety guidelines and warnings for operating the product.
Identifies components of the UAV frame with labels.
Lists and describes electronic components of the UAV.
Details the steps for assembling the drone's main body and wings.
Instructions on how to refuel the drone with the correct fuel mixture.
Explains how to inspect and adjust the drone's center of gravity for stable flight.
Guides on powering up and checking the remote control and ground equipment.
Verifies the proper functioning and logic of the remote control's rudder surfaces and throttle servo.
Details the procedures for inspecting the engine before flight operations.
Covers the inspection process for the RTK positioning system.
Instructions on how to correctly install the rotor propellers on the drone.
Details the technical specifications of the flight controller, including processor, sensors, and interfaces.
Provides detailed specifications for the RTK system, including receiver type, accuracy, and convergence time.
Explains the status lights and interface definitions for the RTK module.
Lists the performance and technical specifications of the EFI engine.
Details the connections and interfaces for the Engine Control Unit (ECU).
Illustrates and explains the interface connections for the UBEC module.
Outlines the technical specifications and capabilities of the battery charger.
Provides detailed specifications for the remote control, including communication distance, channels, and supported models.
Details the overall specifications of the Falcon F390 aircraft, such as dimensions, weight, and performance limits.
Presents a block diagram illustrating the interconnected aircraft load equipment.
Shows a schematic diagram of how equipment is installed within the aircraft.
Provides instructions for wiring the various equipment installed on the aircraft.
Outlines the step-by-step process for conducting flight operations with the drone.
Lists the items to inspect before and after flight for routine maintenance.
Details the specific maintenance procedures to be performed on the F390 UAV after each flight and during storage.
To Next Page
General