Viewpro ZIR35T - 2.2 Control Box Printing

To Next Page

To Previous Page

[1] Control box

[2] Upper damping board

[3] Lower damping board

[4] Infrared thermal camera

[6] Yaw axis motor

[8] Roll axis motor

[7] TF card slot

[9] Pitch axis motor

[10] 3-6S power interface

[11] Micro HDMI interface

[12] Ethernet interface

[13] Viewport unlock button

[5] Damping ball

2.2.1 Control Box Printing (Standard Version)

PITCH

Yellow Jumper Cap

GND

YAW

MODE

ZOOM

FOCUS

PIC/REC

MULTI

USB

5V output

GND

1 2 3

Please ensure that there isn’t any obstacle while the

motor rotating.

Please remove the obstacle immediately if gimbal

camera is blocked during rotation.

Don’t put the infrared thermal camera towards the

sun in case any burn to the camera

The input voltage cannot be higher than 6S.

The pin insertion interface cannot be connected with

power supply.

The yellow jumper cap cannot be removed