To Next Page

To Previous Page

Compliance Information

FCC Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital

device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference when the equipment is operated in a commercial

environment. This equipment generates, uses, and can radiate radio frequency energy and,

if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications. Operation of this equipment in a residential area is likely to cause

harmful interference in which case the user will be required to correct the interference at his

own expense.

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Warning: To comply with the limits for the Class A digital device, pursuant to Part 15 of the

FCC Rules, this device must be installed in computer equipment certied to comply with the

Class A limits. All cables used to connect the computer and peripherals must be shielded

and grounded. Operation with non-certied computers or non-shielded cables may result

in interference to radio or television reception. Changes and modications not expressly

approved by the manufacturer could void the user’s authority to operate this equipment.

For Canada

CAN ICES-3 (B)/NMB-3(B)

ViewSonic EP2203r User Manual

Other manuals for ViewSonic EP2203r