ViewSonic N2201w-1M - Page 7

ViewSonic Corporation Confidential - Do Not Copy N2201w-1M
4
2. Video
Built-in A/D converter shall provide analog to digital converter for this product
3. Audio
Audio amp of this product shall be provided by “ST”with a Model Number of TDA7266. In addition,
a pair of speakers shall be integrated within this product. The audio signals of this product shall comply with
the specification listed in the following table.
Input Parameter Specification
CVBS Characteristics:
Video Amplitude Signal
DC Level Sync Pulse
0.7(min.)-1.1(max.) V
Typical.0.3 V
S-Video Characteristics:
Video Amplitude Signal
Y : 1.0Vp-p W / Neg. Sync (IN 75 ȍ )
C : 0.285Vp-p (IN 75 ȍ )
Y, Pb, Pr Characteristics:
Video Amplitude Signal
Y:1.0Vp-p (IN 75 ȍ)
Pb:0.7 Vp-p (IN 75 ȍ),Pr:0.7 Vp-p (IN 75 ȍ)
Video Bandwidth NTSC: 6 MHz Maximum
HDMI Characteristics Panel Link T.M.D.S HDMI-1.1
RGB Characteristics:
Signal Type
Sync Type
Input Signal Rating
Sync Level:
Frequency Range
Pixel Color
DDC Compliance
EDID Data Table
Analog VGA
TTL, Separate Sync, with 4.7K pull-down resistors
1250mV Max without damage to the product, 0-700 mV Full Range
2.5-5.25 V
Horizontal: 31.5-60K Hz, Vertical: 56-75 Hz
16 M
DDC2B Compliant, Rev 1.3
See Appendix B
Parameter Specification
Tuner Input Base band Input
Power Output Max
Rating
3W at 10 % T.H.D Distortion 3W at 10% T.H.D Distortion
Speaker Impedance
main spk :8 ȍ main spk : 8ȍ
Line In Per Tuner Spec
500 mV rms (Typ)
1.6 V rms (Max)
Impedance: 600 ohms
Flatness of Amplitude
Response
+/- 3 db (at 1KHz @1W) +/- 3 db (at 1KHz @1W)
Total Harmonic Distortion
(Po=0.1 to 1W, f=1KHz)
<2% <2%
Signal to Noise:
30dB @1 kHz 40dB @1 kHz