ViewSonic N2635W - Page 40

35
ENGLISH
Contact ViewSonic service team at: http://www.ViewSonic.com or call our service team: United States 1-800-688-6688, Canada 1-866-463-4775
ViewSonic N2635w
Using the TV Features
Using VGA Function
1. When in VGA source, press the MENU button to
display the OSD main menu.
3UHVVŻRUŹWRVHOHFWWKH³9LGHR´PHQX
3UHVVŸRUźWRVHOHFW\RXUGHVLUHGFRQWUROVDQGSUHVV
ŻRUŹWRDGMXVW
4. For advanced VGA functions, select “VGA” (only
enabled in VGA source) and press ENTER to enter
VGA setting.
3UHVVŸRUźWRVHOHFW³+3RVLWLRQ´³93RVLWLRQ´
³3KDVH´RU³&ORFN´DQGDGMXVWWKHOHYHOZLWKŻRUŹ
ŎWhen in VGA source, the Audio, Setup, and Parental
menus are the same as or similar to when in other source.
Instead that some controls are disabled.
ŎWhen there is no signal in the VGA mode, “No signal.
The power will be turned off.” will be displayed on the
screen, and the TV will automatically turn into power-
saving mode after a few seconds’ idleness. Press any key
on the remote control at any time and the TV will return
to VGA mode.
To Restore Factory Setting
1. Press the MENU button to display the OSD main menu.
3UHVVŸRUźWRVHOHFWWKH³6HWXS´PHQX
3. Press ENTERRUŹWRHQWHU³6HWXS´PHQX
3UHVVŸRUźWRVHOHFW³0HPRU\5HFDOO´WKHQSUHVV
ENTER to restore the factory default setting.
Change Password:
3UHVVŸRUźWRVHOHFW³&KDQJH3DVVZRUG´WKHQSUHVV
ENTER to enter “Change Password” setting.
2. Enter your new password in “New Password”.
(QWHUWKHQHZSDVVZRUGDJDLQLQ³&RQ¿UP3DVVZRUG´
After you complete the last step, the screen will return
to the top page of Parent menu. If so, the password has
been changed successfully.