ViewSonic VA1721WMB - Disassemble Process

- 57 –
ViewSonic Corporation
Confidential - Do Not Cop VA1721wmb
9. Disassemble Process
9.1 Units Disassemble Process
9.1.1 Tools
 Glove
 Big cross screwdriver
 Small cross screwdriver
 Prize equipment or abandoned IC card
 Screw box
 Cushion
 Six angle sleeve spanner
9.1.2 Disassemble process
1、 Tide up the worktable, spread straight cushion, put the monitor on it, the front side
adown.(Picture 1)
2、 Remove the decorate slice of the back cover.(Picture 2, 3)
3、 Disassemble the 4 screws that fix the stand, remove the stand.(Picture, 4)
4、 Disassemble the 4 screws of the back cover.（Picture 5）
5、 Use equipment or abandoned IC card to prize up the bezel through the bottom flute,
and rip up the back cover downwards.( as showed in the following the picture 6,7,8,9)
6、 Disassemble the 6 screws and 4 pins of the Key board, remove the Key board. ( as
showed in the following the picture 10,11)
7、 Remove the bezel, refer to the following picture 12.
8、 Disassemble the 2 pins of the backlight, as showed in the following the picture 13,14.
9、 Disassemble the 4 fixed screws of the panel, as showed in the following the
picture15,16.
10、 Lift up the main frame and lift down the LVDS connectors according to the direction of
the arrowhead, refer to the following picture 17,18.
11、 That’s all. The disassemble process of the unit is over.
9.1.3 Show pictures
：
（Picture 1） （Picture 2）