Disassemble Process
1 Units Disassemble Process
1.1 Tools
Glove
Big cross screwdriver
Small cross screwdriver
Prize equipment or abandoned IC card
Screw box
Cushion
Six angle sleeve spanner
1.2 Disassemble process
1、 Tide up the worktable, spread straight cushion, put the monitor on it, the front side
adown.(Picture 1)
2、 Remove the decorate slice of the back cover.(Picture 2, 3)
3、 Disassemble the 4 screws that fix the stand, remove the stand..(Picture, 4)
4、 Disassemble the 4 screws of the back cover.（Picture 5）
5、 Use equipment or abandoned IC card to prize up the bezel through the bottom flute,
and rip up the bezel downwards.( as showed in the following the picture 6,7,8)
6、 Disassemble the 3 screws and 3 pins of the Key board, remove the Key board. ( as
showed in the following the picture 9,10)
7、 Remove the back cover, refer to the following picture 11.
8、 Disassemble the 3 fixed screw in the shield, remove the shield as the direction
arrowhead showed, refer to the following picture 12.
9、 Disassemble the 5 screws and 4 pins of the PWPC board, remove the PWPC
board.(symbolized the following picture 13 with red color)
10、 Disassemble the 2 screws and 4 pins of the audio board, remove the audio board.
(symbolized the following picture 13 with yellow color)
11、 Disassemble the 3 screws and 2 pins of the main board, remove the main board.
(symbolized the following picture 13,14 with blue color)
12、 Disassemble the 4 fixed screws of the panel, remove the main frame, as showed in
the following the picture 15,16,17. Do not damage the cable of the panel.
13
、 That’s all. The disassemble process of the unit is over.
ViewSonic Corporation VA503b-1_ VA503m-1
44
Confidential - Do Not Copy
To Next Page
Loading...
