4/4
(2).Please pay attention to the sequence of the installation steps to avoid repeated
disassembly.
(3). Make sure hibernate and sleep are disabled when working long hours. This feature may
cause the laser to continue to glow out of control, and burning on the table.
(4). It is strictly prohibited to use this machine unattended.
(5). Make sure to wear protective glasses before operating the laser.
FAQ
The control software
cannot be opened
Please check whether the system is Win7 or above.
The carving is not
good or there is no burned
trace
Please check whether the focal length of laser is in the recommended distance.
Please check whether the laser focus is at a minimum.
Please check whether the object to be caved is laid flat.
Please check whether the laser is in weak light mode.
Please check whether the power indicator light on the control panel is continuous
lighting.
Please check whether the motors are working properly.
The stepper motors
are not working properly
Please check whether the connection between the three motors and control board
is correct.
Please check for any irrelevant stuff on the slide to block movement.
Please check whether the motor drive current is normal. Too little current causes
the motors to stall. Too much current makes the motors to vibrate, and causes the
movement of the machine or materials to be carved.
Please check whether the power indicator light on the control panel is continuous
lighting.
5. Update
Our software will be updated continuously.
Please visit our website: www.vigotec.cn for more new products and software.
Please be sure to download the VigoEngraverL7 for this machine.
Please refer to the Software Installation Manual for control software instructions.
Please contact us if you have any questions.
6. Warning
Strictly prohibit laser irradiation of the eyes!
Strictly prohibit watching laser without wearing protective glasses!
Strictly prohibit using by children!
Strictly prohibit using this machine unattended!
Powered by VigoTec 2019.
To Previous Page
Loading...