28
Installation Procedure (French Door- Upper Door Adjustment)
There may be ocassions where the upper doors are not aligned to the same height, especially if doors were
removed for maintenance and then reinstalled. With doors in the closed position determine the alignment
required, for example right door is higher than left door.
Alignment procedure:
1. Open doors fully
2. Loosen bottom hinge screws on both doors, see photos below.
Using a 5/32” allen wrench, adjust screw on each door shown below moving the door that is too high
downward and the door that is low upward. You want to adjust both in opposite directions, not just one door.
Note that this moves the lower hinge assembly when adjusted.
Close doors and check alignment, when
alignment is correct, open doors and tighten the
lower hinge plate screws that you loosened at
beginning of procedure.
To Next Page
Loading...
