29
A qualified installer should carry out the following checks:
1. Check oven bake function–bake element on full power, center and outside broil elements at partial power.
Convection bake function– bake and broil elements the same with the convection fan on.
2. Check TruConvec™ function– TruConvec element (behind convection fan cover) on and convection fan on.
3. Check high broil function–both broil elements at full power. Convection broil function is the same with
convection fan on.
4. Check medium broil function–inner and outer broil elements pulse on and off.
5. Check low broil function–inner broil element only.
6. Check self-clean function–Door will lock in approximately 30 seconds, the center and outside broil elements
will turn on and the bake element will turn on at partial power. Check broil elements through window to
make sure they are on, then abort self-clean cycle to unlock door.
CAUTION: Do not run self-clean cycle check for more than 10 minutes with the oven racks and rack supports
inside oven to avoid discoloration due to the high temperature.
Any adjustments necessary that are a result of the installer not following instructions will be the responsibility
of the installer, dealer or the end user of the product.
Performance Checklist
To Next Page
Loading...
