TURBO/WHIRLPOO JET (Viking 2P & 3 only)
VOLCANO Jet (Heritage & Tradition only)
The Turbo jet is located on the filter cavity wall is
the Turbo jet. This jet is a combination valve
and high capacity jet. To turn the Turbo jet on,
simply turn the face counter-clockwise to the first
stop position. To turn the Turbo jet off, turn the
face clockwise to bring the main jets back to full
power.*
The Volcano Jet operates on a valve
located in the middle of the lounger. Turn
the valve to activate the jet. Note: this valve
directs one of the pumps and will effect the
flow
this pump used to power other jets in the spa.
* Due to the substantial amount of water pressure when the Turbo Jet is
operating, you must turn the pump to the off or low speed cycle position
before attempting to rotate the jet face.
AIR CONTROLS
Air controls are adjusted by rotating the topside dial. These controls
serve to regulate the amount of air mixed with water when the whirlpool
or hydrotherapy jets are operating in the high pump mode.
13
All other models (See illus-
tration on page 14)
Viking 1P, 2P & 3 only
To Next Page
Loading...
Need help?
General
