Page 3For technical questions, please call 1-888-866-5797.Item 58759
IMPORTANT SAFETY INSTRUCTIONS
The warnings and precautions discussed in this
manual cannot cover all possible conditions and
situations that may occur. It must be understood
by the operator that common sense and caution
are factors which cannot be built into this product,
but must be supplied by the operator.
1. Use only according to these instructions.
Improper setup can create hazards.
2. Wear ANSI-approved safety goggles and
heavy-duty work gloves during setup and use.
3. Be extra cautious to reduce risk of dropping
a metal tool onto battery. It might spark
or short-circuit battery or other electrical
part that may cause explosion.
4. Keep work area clean and well lit.
5. Keep bystanders out of the area
during setup and use.
6. Do not use when tired or when under the
influence of drugs or medication.
7. This product is not a toy. Do not allow
children to play with or near this item.
8. Inspect before every use; do not use
if parts are loose or damaged.
9. Do not smoke or have open flames near the battery.
10. Do not connect the Tester to the battery while the
engine is running.
Turn the engine off before connecting.
11. If battery has just been charged, ventilate
the area thoroughly before testing it. Be
careful to avoid creating sparks.
12. Do not disassemble charger; take it to a qualified
technician when service or repair is required.
13. Have plenty of fresh water and soap nearby in
case battery acid contacts skin, clothing, or eyes.
14. If battery acid contacts skin or clothing,
wash immediately with soap and water. If
acid enters eye, immediately flood eye with
running cold water for at least 10 minutes
and get medical attention immediately.
15. Maintain product labels and nameplates.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
SAVE THESE INSTRUCTIONS.
To Next Page
Loading...
