The E-60 Series entry phones are compact, vandal resistant, telephone line powered speaker phones designed to provide two-
way handsfree communication. The E-60's compact size allows it to be mounted in a standard double gang electrical box. The
E-60 is available in five different attractive finishes to match your door hardware, light fixtures, etc. Replacement E-60 faceplates
(PNL60) can be purchased separately and are available in all five standard finishes. The E-60’s blue LED continually provides
light for locating the push button in dark locations, dims to indicate off hook and flashes during incoming ring.
The E-60 entry phones can share a single phone line with house or small business telephones when used with a Viking model
C-200 or C-2000A Entry Phone controller. The E-60 entry phones can also be connected to an unused analog station port (pro-
grammed for ring down) on a phone system or connected directly to a telephone line when used with a Viking model K-1900-5
auto dialer. The E-60 features microphone and speaker volume controls, selectable auto answer for monitoring and intelligent
call progress detection for automatic hang-up when the call is completed. For outdoor environments or corrosive atmospheres,
the E-60 Series is available with Enhanced Weather Protection (EWP).
Entry Phones Now Mount in a Standard Double Gang Box
• Compact size: Front panel is the size of a typical double gang mid-
size wall plate
• Mounting: Flush mounts in a double gang electrical box (2.25”
deep x 3.7” wide x 2.84” tall minimum) or surface mounts in a Viking
model VE-5x5 (not included, see DOD# 424) for mounting to a wall,
post or VE-GNP Gooseneck Pedestal (EWP recommended)
• Available in 5 standard faceplate finishes: Brushed Stainless Steel,
Oil Rubbed Bronze, Polished Brass, Satin Black and Satin White
• PNL-60 faceplates: Replacement faceplates with matching screws
available in all five standard finishes
• Features: Mylar speaker, faceplate gasket, mic and speaker gasket,
internally sealed (IP67) push button switch, self draining mic mount
and UV stable weather resistant powder coating (excludes E-60-SS
stainless steel faceplate)
• Vandal Resistant Features: 16 gauge polished brass or 18 gauge
stainless steel faceplate, stainless steel push button, stainless
steel speaker screen, scratch resistant powder coating, hex drive
mounting screws
• Optional Enhanced Weather Protection (EWP, recommended for
outdoor applications) Features: Urethane potted circuit board,
internally sealed POTS and dip switches, potted microphone and
push-button switch, etc.
• Blue LED helps locate the push button, indicate ringing and off-hook
• Telephone line powered
• Microphone and speaker volume controls
• Programmable Intelligent call progress detection for automatic
hang-up on CPC, silence, busy signal, or time out
P
P
r
r
a
a
c
c
t
t
i
i
c
c
e
e
T
T
E
E
L
L
E
E
C
C
O
O
M
M
S
S
O
O
L
L
U
U
T
T
I
I
O
O
N
N
S
S
F
F
O
O
R
R
T
T
H
H
E
E
2
2
1
1
S
S
T
T
C
C
E
E
N
N
T
T
U
U
R
R
Y
Y
TECHNICAL
TECHNICAL
F
F
e
e
a
a
t
t
u
u
r
r
e
e
s
s
E-60 Series
E-60 Series
Double Gang Entry
Phones with LED
November 19, 2008
Power: Telephone line powered. Minimum 18V DC talk battery voltage with a minimum
loop current of 20mA. Loop current may be boosted on low current lines with a Viking
model TBB-1A Talk Battery Booster (see Fax Back Document 630).
Dimensions: Faceplate: 123.8mm x 125.4mm x 4.3mm (4.875” x 4.938” x 0.17”), Phone:
72mm x 46mm x 42mm (2.84” x 1.8” x 1.65”)
Shipping Weight: 0.55 kg (1.2 lbs)
Operating Temperature: -34° C to 65° C (-30° F to 150° F)
Humidity: Standard model: 5% to 95% non-condensing humidity, EWP model: up to
100% humidity
Speaker Volume: Approximately 62db maximum @ 1m
Ring Voltage: 25V AC RMS minimum (for auto answer)
CPC Disconnect Time: 300ms minimum
REN: 0.8A
Connections: (2) gel-filled butt connectors
S
S
p
p
e
e
c
c
i
i
f
f
i
i
c
c
a
a
t
t
i
i
o
o
n
n
s
s
E-60-SS
“Brushed Stainless Steel”
(similar to brushed nickel)
E-60-BN
“Oil Rubbed Bronze”
(satin dark brown powder
paint with fine copper metallic)
• Door or gate communication, business delivery entrances
• Use with a Viking C-200 to control one E-60 on a single phone line
• Use with a Viking C-2000B to control 1 to 4 E-60’s and door/gate
control on a single phone line
• Provide unique front and back door chimes and paging when used
with a Viking SLP-1 or SLP-4 and C-2000B
• Residential, commercial and industrial door security
• Use with a Viking K-1900-5 for automatic speed dialing on tele-
phone lines or analog PABX/KSU station ports
• Use on any analog PABX station port with programmable ringdown
capability
A
A
p
p
p
p
l
l
i
i
c
c
a
a
t
t
i
i
o
o
n
n
s
s
E-60-PB
“Polished Brass”
(with clear gloss powder
paint to prevent tarnishing)
E-60-WH
“Satin White”
(satin white powder paint)
E-60-BK
“Satin Black”
(fine texture satin black
powder paint)
?
Need More Information on EWP?
Call (715) 386-4345 and select 859.
To Next Page
Need help?
General
