Viking MB 545 VM - Troubleshooting

55
DEFRNLITESPTNOSVFIDAPLSLSKTR EN
0478 111 9932 B - EN
Transporting lithium-ion batteries:
MB 545.1 VE: The lithium-ion batteries
used meet the requirements specified in
UN manual ST/SG/AC.10/11/Rev. 5
Part III, subsection 38.3.
The user may carry these batteries to the
place of use of the machine without further
restrictions during road transport.
Country-specific legislation must be
observed in the case of air or sea
transport.
For further transport instructions, see
www.viking-garden.com/safety-data-
sheets
Fault:
Engine not starting
Possible cause:
– Motorstop lever not pressed.
– MB 545 VE: Battery discharged or
defective.
– No fuel in tank; fuel line blocked.
– Inferior, dirty or old fuel in tank.
Cutter bar speed 2800 rpm
Cutting heights 25 - 80 mm
Wheel diameter
(rear) 200 mm
Self-propulsion, rear
wheels Vario
Weight 31 kg
Sound emissions
In accordance with Directive 2000/14/EC:
Guaranteed sound
power level L
WAd
96 dB(A)
In accordance with Directive 2006/42/EC:
Sound pressure level
at workplace L
pA
83 dB(A)
Uncertainty K
pA
2 dB(A)
Hand-arm vibrations
Specified vibration characteristic in
accordance with EN 12096:
Measured value a
hw
4,10 m/sec²
Uncertainty K
hw
2,05 m/sec²
Measurement in accordance with
EN 20643
MB 545.1 VM:
Engine type
designation Series 650 EXi
Displacement 163 ccm
Nominal output at
nominal speed
2,4 - 2800
kW - rpm
Starter Rope start
Fuel tank 1,0 l
Cutter bar speed 2800 rpm
Cutting heights 25 - 80 mm
Wheel diameter
(rear) 200 mm
Self-propulsion, rear
wheels Vario
Weight 30 kg
MB 545.1 VE:
Sound emissions
In accordance with Directive 2000/14/EC:
Guaranteed sound
power level L
WAd
95 dB(A)
In accordance with Directive 2006/42/EC:
Sound pressure level
at workplace L
pA
82 dB(A)
Uncertainty K
pA
2dB(A)
Hand-arm vibrations
Specified vibration characteristic in
accordance with EN 12096:
Measured value a
hw
4,10 m/sec²
Uncertainty K
hw
2,05 m/sec²
Measurement in accordance with
EN 20643
MB 545.1 VR:
Engine type
designation Series 650 EXi
Displacement 163 ccm
Nominal output at
nominal speed
2,4 - 2800
kW - rpm
Starter Rope start
Fuel tank 1,0 l
Cutter bar speed 2800 rpm
Cutting heights 20 - 75 mm
Roller diameter (rear) 90 mm
Roller drive Vario
Weight 30 kg
Sound emissions
In accordance with Directive 2000/14/EC:
Guaranteed sound
power level L
WAd
95 dB(A)
In accordance with Directive 2006/42/EC:
Sound pressure level
at workplace L
pA
82 dB(A)
Uncertainty K
pA
2dB(A)
MB 545.1 VM:
Hand-arm vibrations
Specified vibration characteristic in
accordance with EN 12096:
Measured value a
hw
4,80 m/sec²
Uncertainty K
hw
2,40 m/sec²
Measurement in accordance with
EN 20643
19. Troubleshooting
# If necessary, contact a specialist
dealer; VIKING recommends VIKING
specialist dealers.
@ See engine instruction manual.
MB 545.1 VR: