57
DEFRNLITESPTNOSVFIDAPLSLSKTR EN
0478 111 9932 B - EN
Fault:
Excessive vibration during operation
Possible cause:
– Blade fastening screw loose.
– Blade imbalance due to incorrect
sharpening or fracture.
– Cutting unit defective.
– Engine mounting loose.
Remedy:
– Tighten blade fastening screw. (Ö 12.4)
– Re-sharpen (balance) or replace blade.
(Ö 12.5), (Ö 12.6), #
– Check blade, blade shaft and blade
fastening and repair if necessary. #
– Tighten engine mounting bolts. #
20.1 Handover confirmation
20.2 Service confirmation
Please hand this instruction manual
to your VIKING specialist dealer in
the case of maintenance work.
He will confirm the service operations
performed in the pre-printed boxes.
20. Service schedule
Service performed on
Next service date
32
To Next Page
Loading...
