Viking Plug-n-Play Spas V 300 User Manual

Owner’s Manual
V 1 0 0
V 3 0 0 / V 5 0 0
2014

Viking Plug-n-Play Spas V 300 Specifications

General

Pump	1.5 HP
Water Capacity	180 gallons
Shell Material	Acrylic
Cabinet Material	Synthetic Wood
Insulation	Foam
Warranty	5 years

Summary

Important Safety Instructions

Personal Safety Precautions

Specific precautions for personal safety and user conduct in the spa.

Installation and Set-Up Instructions

Surface and Pad Requirements

Requirements for the spa's foundation and placement surface.

Balconies and Deck Requirements

Electrical Requirements (All Models)

Specifications for spa electrical connections and safety.

Spa Startup Directions

Apply Power

Procedures for safely applying electrical power to the spa.

Electrical Specifications

Technical details regarding the spa's electrical system.

Operation Instructions

Topside Control Instructions

Initial Start-Up

Temperature Settings

How to set and adjust the spa water temperature.

Diagnostic Messages

HH - Overheat

Spa shut down due to high heater temperature (118°F/48°C).

OH - Overheat

Spa shut down due to high water temperature (110°F/43°C).

IC - Ice Condition

SA - Sensor A Error

SB - Sensor B Error

Sn - Sensors Out of Balance

HL - Sensor Difference

LF - Low Flow

dr - Heater Flow Issue

dy - Heater Flow Issue

Maintenance

Skimmer Side Filter

Add Start-Up Chemicals

Guidance on adding chemicals for initial water balance.

Filter Cleaning

Trouble Shooting

Spa Will Not Heat

Troubleshooting steps for when the spa fails to heat properly.

Pump Will Not Prime or Function

Diagnosing and fixing issues with the spa pump not priming or running.

No Function

Solutions for when the spa system shows no response or power.