EasyManua.ls Logo

Viking VINV600 - User Manual

Viking VINV600
8 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR
INJURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer or your
distributor.
2. Before servicing or cleaning unit, switch power off at service
panel and lock the service disconnecting means to prevent
power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a
prominent warning device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by a
qualified person(s) in accordance with all applicable codes
and standards, including fire-rated construction codes and
standards.
4. Sufficient air is needed for proper combustion and exhausting
of gases through the flue (chimney) of fuel burning equipment
to prevent backdrafting. Follow the heating equipment
manufacturer’s guidelines and safety standards such as
those published by the National Fire Protection Association
(NFPA), and the American Society for Heating, Refrigeration
and Air Conditioning Engineers (ASHRAE), and the local code
authorities.
5. When cutting or drilling into wall or ceiling, do not damage
electrical wiring and other hidden utilities.
6. Ducted fans must always be vented to the outdoors.
7. Do not use this unit with an additional speed control device.
8. To reduce the risk of fire, use only steel ductwork.
9. This unit must be grounded.
TO REDUCE THE RISK OF A RANGE TOP GREASE FIRE:
1. Never leave surface units unattended at high settings.
Boilovers cause smoking and greasy spillovers that may ignite.
Heat oils slowly on low or medium settings.
2. Always turn hood ON when cooking at high heat or when
cooking flaming foods.
3. Clean ventilating fans frequently. Grease should not be allowed
to accumulate on fan or filter.
4. Use proper pan size. Always use cookware appropriate for the
size of the surface element.
TO REDUCE THE RISK OF INJURY TO PERSONS IN THE
EVENT OF A RANGE TOP GREASE FIRE, OBSERVE THE
FOLLOWING:*
1. SMOTHER FLAMES with a close-fitting lid, cookie sheet,
or metal tray, then turn off the burner. BE CAREFUL TO
PREVENT BURNS. If the flames do not go out immediately,
EVACUATE AND CALL THE FIRE DEPARTMENT.
2. NEVER PICK UP A FLAMING PAN - You may be burned.
3. DO NOT USE WATER, including wet dishcloths or towels -
violent steam explosion will result.
4. Use an extinguisher ONLY if:
A. You know you have a Class ABC extinguisher and you
already know how to operate it.
B. The fire is small and contained in the area where it started.
C. The fire department is being called.
D. You can fight the fire with your back to an exit.
* Based on “Kitchen Fire Safety Tips” published by NFPA.
CAUTION
1. For general ventilating use only. Do not use to exhaust
hazardous or explosive materials and vapors.
2. To avoid motor bearing damage and noisy and/or
unbalanced impellers, keep drywall spray, construction dust,
etc. off power unit.
3. Your ventilator motor has a thermal overload which will
automatically shut off the motor if it becomes overheated.
The motor will restart when it cools down. If the motor
continues to shut off and restart, have the hood serviced.
4. Please read specification label on product for further
information and requirements.
Model VINV600 Ventilator Kit
!
Blower Dimensions
9.50 x 8.50 x 8.50
MOUNTING PLATE CONFIGURATIONS:
020970-000
USE ON DCWH30421, DCWL33421,
DCWN3042, DTWS 30" THRU 42", DBCV 30"
THRU 42" HOODS
020971-000
USE ON VCWH & VCIH 30" THRU 42" HOODS
020972-000
USE ON DCWH, DCIH, DCWL, DCWN, DTWN
36" THRU 42", VWH, VIH, VBCV, VICV 24"
THRU 42" HOODS
050722-000
USE ON VBCV53638 AND VBCV54238
HOODS
FOR USE ONLY WITH
VIKING HOOD MODELS *
DCWH, DCWL, DCIH, DLWN, DTWS,
DTWN, DBCV, DICV, VCIH, VWH, VIH,
VBCV, VICV
* Contact your local Viking dealer for specific
compatibility information.
Question and Answer IconNeed help?

Do you have a question about the Viking VINV600 and is the answer not in the manual?

Summary

General Safety Warnings

General Safety Precautions

Observe safety precautions to reduce risk of fire, electric shock, or injury during operation.

Grease Fire Prevention

Steps to prevent and manage range top grease fires, including unattended cooking.

Grease Fire Injury Prevention

Actions to take to prevent injury during a range top grease fire.

Cautions and Specifications

General Cautions

Important cautions for general use, motor protection, and proper operation.

Compatibility Information

Lists Viking hood models compatible with the ventilator kit.

Blower Dimensions

Specifications for the blower dimensions.

Mounting Plate Configurations

Details specific mounting plate part numbers for various Viking hood models.

Ventilator Kit Installation

Select Mounting Plate

Instructions on selecting the correct mounting plate based on hood series.

Attach Damper

Steps for attaching the damper to the mounting plate using hex screws.

Apply Neoprene Washers

Guidance on applying neoprene washers to mounting plate studs.

Attach Blower to Mounting Plate

Procedure for attaching the blower to the mounting plate with hex nuts.

Attach Assembly to Hood

Steps for mounting the blower/plate assembly to the hood's threaded studs.

Connect Power Cord

Instructions for plugging the blower's power cord into the hood receptacle.

Secure Wiring

Guidance on using a wire tie to secure wiring.

Summary

General Safety Warnings

General Safety Precautions

Observe safety precautions to reduce risk of fire, electric shock, or injury during operation.

Grease Fire Prevention

Steps to prevent and manage range top grease fires, including unattended cooking.

Grease Fire Injury Prevention

Actions to take to prevent injury during a range top grease fire.

Cautions and Specifications

General Cautions

Important cautions for general use, motor protection, and proper operation.

Compatibility Information

Lists Viking hood models compatible with the ventilator kit.

Blower Dimensions

Specifications for the blower dimensions.

Mounting Plate Configurations

Details specific mounting plate part numbers for various Viking hood models.

Ventilator Kit Installation

Select Mounting Plate

Instructions on selecting the correct mounting plate based on hood series.

Attach Damper

Steps for attaching the damper to the mounting plate using hex screws.

Apply Neoprene Washers

Guidance on applying neoprene washers to mounting plate studs.

Attach Blower to Mounting Plate

Procedure for attaching the blower to the mounting plate with hex nuts.

Attach Assembly to Hood

Steps for mounting the blower/plate assembly to the hood's threaded studs.

Connect Power Cord

Instructions for plugging the blower's power cord into the hood receptacle.

Secure Wiring

Guidance on using a wire tie to secure wiring.

Viking VINV600 Specifications

General IconGeneral
BrandViking
ModelVINV600
CategoryFan
LanguageEnglish

Related product manuals