9
Warning! Use only original manufacturer's replacement parts, accessories and attachments.
Failure to do so can cause poor performance, possible injury and may void your warranty. Never
use the machine without the guard assembled!
4. Assemble the cutting head.
4.1 Release the nut. Line up the two holes of flange and shield, use one screw driver to hold the
flange as below and turn the socket wrench clockwise, the nut will be released.
4.2 Fit the Nylon cutting head. Remove another shield after release the nut. Still hold the
flange, take the Nylon cutting head on the shaft and rotate counter-clockwise, the Nylon
cutting head is fitted.
To Next Page
Loading...