Why is there cold supply air from my villavent VR-400 EV/B Fan?
If you are experiencing cold supply air, check the set supply air temperature on the control panel. Also, check if the fire protection thermostat has tripped; if so, press the "I" button on the unit. Inspect the exhaust air filter for dirt and ensure the exchanger is rotating.
What to do if my villavent VR-400 EV/B Fan is not running?
If the fan is not starting, check that the fuses are intact and all connectors are properly connected. Ensure all plugs, including the mains and fan plugs, are correctly inserted.
What to do if Villavent Fan cannot be controlled?
If the unit's control is unresponsive, reset the settings by unplugging the power cord for 20-30 seconds.
How to fix reduced airflow in my Villavent Fan?
To address reduced airflow, first check the setting. Have you forgotten to change the filter? Is it necessary to clean the outlets/valves? Is it necessary to clean the fans and heat exchangers? Is the suction grille clogged? Inspect the visible parts of the duct network for damage or contamination. Ensure all outlets/valves are open or that the opening cross-section has not been reduced.
Why is my villavent VR-400 EV/B making noise or vibrating?
To address noise or vibrations, start by cleaning the fan. Then, check that the fan screws are tightened securely.
Select fan speed across three levels using up/down buttons on the control panel.
Adjust supply air temperature across five levels via control panel buttons.
Details on connecting and operating the Villavent kitchen hood with the ventilation unit.
Utilizing a timer for automatic reduced ventilation during off-peak hours.
Essential guidelines to prevent electrical hazards, fire, and damage from improper use.
Procedure for changing disposable filters and resetting filter service intervals.
Instructions for periodic inspection and cleaning of the heat exchanger.
Steps to diagnose why the fan fails to start, checking fuses and connections.
Identifying causes of reduced airflow and performing necessary checks.
How to reset the unit's electronics when the control panel is unresponsive.
Checking temperature settings and thermostat to resolve cold supply air.
Procedures for identifying and rectifying noise or vibration problems.
Understanding lamp signals that indicate specific faults or operational states.
Guidelines for contacting service personnel and noting required unit information.
General| Model | VR-400 EV/B |
|---|---|
| Voltage | 230V |
| Frequency | 50 Hz |
| Airflow | 400 m³/h |
| Filter Type | G4 |
| Bypass | Yes |
| Mounting | Wall-mounted |
To Next Page
