28
41002 - 41005
In this section, you can configure the release of the lock (from a secondary outdoor station) in common with one or more
main outdoor stations.
Common locks
Press repeatedly, until the
LEDs light up as in the
previous section, to select
the function.
Press to confirm
If there is more than one main outdoor station, from
the main outdoor station you wish to communicate
from, make a call to any indoor station installed on
the same bus where the secondary outdoor station is
located.
Make sure the indoor station sends the door release
command to the main entrance panel you wish to
associate.
If a previous programming using SaveProg
exists, press to delete the table of common
locks from the secondary station.
This operation is confirmed by a dedicated
tone.
Press to confirm deletion
N.B.: The function is available from firmware version 1.81 (also after update).
To Next Page
Loading...
Need help?
General
