Need help?Do you have a question about the Vimpex hydrosense HSHWI-100 and is the answer not in the manual?
Details the various components used for water detection in the Hydrosense system.
Covers Hydrowire cable, EOL device, and connection interface for linear detection.
Details floor probes and their associated junction boxes for point detection.
Describes control panels and mimic displays for system monitoring and control.
Details the HSCP series control panels and their features for system management.
Provides guidance on planning the system layout, design notes, and installation.
Details safety precautions, regulatory requirements, and correct panel mounting methods.
Instructions for connecting the circuit board, remote inputs, and RS485 bus.
Covers ancillary boards, sounder wiring, and detection zone wiring.
Explains fault, local alarm, and general alarm relay operations.
Details how to access and modify system settings using Access Level 2.
Explains how to access and use Access Level 3 for system configuration.
Describes internal switches (Watchdog, Processor Reset) and indicator LEDs.
Step-by-step guide for installing Hydrowire cables, interfaces, and wiring.
Instructions for commissioning Hydrowire, including testing and layout diagrams.
Procedure for mounting, connecting, and wiring floor probes and junction boxes.
Details methods for testing floor probes and shows typical probe layout diagrams.
General| Brand | Vimpex |
|---|---|
| Model | hydrosense HSHWI-100 |
| Category | Industrial Equipment |
| Language | English |
To Next Page