Vincent
39
ADVANCED PLAYBACK FUNCTIONS
Operation Button(s) Description
Program the
playback order
PGM (28)
Number
Keys
(18)
With this function it is possible to set up a desired playing sequence of the
CD tracks. This also allows you to play a smaller selection of your own
choice from all the CD tracks. This programming can only be done with
the remote control. The “program” is set up by the following procedure:
• Press the button “PGM”
• Enter the numbers of all the desired tracks one after the other on
the number pad of the remote control. For track 10 use the “10”
button. For all other two-figure track numbers first press the “10+”
button as many times as necessary until the number of 10’s is cor-
rect, then press the button for the last figure (for track 23 press the
“10+” button twice and the “3” button once).
• To confirm the program press “PGM” or “PLAY/PAUSE” (8)(22).
The “REPEAT” play function (21) can also be applied to the programmed
track selection. You can see on the display (1) from the text “PGM” that a
program is active. It is only if you press “CANCEL” (27), eject the CD or
switch off the CD player that your own playing sequence is deleted.
Indication of the
remaining playing time
REMAIN (17)
After pressing this remote control key while the CD is playing, the remai-
ning time of the current track will be shown (indicated by the text
“REMAIN” in the display (1)). Pressing the key again switches the display
to the remaining playing time of the entire CD or the entire program, with
the display then showing “REMAIN ALL”. Pressing the key a third time swit-
ches back to the normal playing time display.
OPERATING THE APPLIANCE
CD-400 Korr2_Bedienungsanleitung 14.09.11 16:28 Seite 39
To Next Page
Loading...
