W Series Presentation Row
Installation Instructions for WS-PR-1C & WS-PR models
• (1) Presentation Row Rack
(13” [331mm] or
39” [991mm] wide)
Parts List
Fasteners We recommend the following fasteners for these surfaces:
• Drywall: Use included toggle bolts and Spiral anchors
• Wood/stud (must be 1/2” (13mm) thick): Use included wood screws
• Concrete, Brick or Stucco: 3/16” x 1-1/4” masonry screw or #8 x 1-1/4” screw with appropriate size ex-
panding concrete anchor
• VintageView W Frames (FCF-xx): Each Frame comes with self-drilling screws to attach Presentation Row
• (2) Plastic Couplers
• (4 or 8) Mounting Hole Caps
• (2 or 4) Spiral Drywall Anchors
• (4 or 8) Screws
• (2 or 4) Toggle Bolts
• Phillips Head Screw Driver
• Level
• Pencil
Required Tools
• Tape Measure
• Power Drill
• 1/2” (12mm) drill bit
IMPORTANT NOTES:
• The W Series Presentation Row is designed to fit directly above or below one column (WS-PR-1C) or three
columns (WS-PR) of W Series Wine Racks.
• When installing above W Series Wine Racks, it is recommended to install the Presentation Row first, as this will
simplify the installation of the racks below and is necessary to allow Racks to couple side-to-side. Additionally, it
is strongly recommended that in places where the racks will line up with each other, the end plugs are removed
and/or replaced with couplers prior to installation of the Presentation Rows, for ease of access.
• 1/16” (2mm) drill bit
To Next Page
Need help?
General