Why can't I change cutting conditions on my Vinyl Express Q60 Plotter?
If the currently selected cutting conditions are disregarded or cannot be changed on your Vinyl Express Plotter, the parameter priority setting is likely set to program mode. Change the parameter priority setting to manual mode.
Why is the cutting size wrong on my Vinyl Express Q60 Plotter?
If the cutting results from your Vinyl Express Plotter differ from the specified size, the programmable resolution (STEP SIZE) may be set differently on the plotter and the software application. Ensure that both the plotter and the software are set to the same resolution.
Why was cutting performed with the ORIGIN point moved to the CENTER on my Vinyl Express Q60?
If cutting was performed with the ORIGIN point moved to the CENTER on your Vinyl Express Plotter, the origin point might be set at the center although the plot data was created based on a center origin (only when the command setting is HP-GL.) Set the application software's origin point to either the lower left point or the center.
What to do if 'POSITION ERROR' is displayed on my Vinyl Express Q60?
If the Vinyl Express Plotter displays 'POSITION ERROR' during initialization, cutting, or plotting, it might be due to incorrect media settings. Try reducing the speed, cutting force, or pen force to resolve this.
Why does my Vinyl Express Plotter stop cutting before the end of the design?
If your Vinyl Express Plotter isn't cutting beyond a certain length, the PAGE LENGTH setting is likely incorrect. Press the ENTER key to check the cut area, and then set the PAGE LENGTH correctly.
Why does media skew on my Vinyl Express Plotter?
If the media skews as soon as it starts to move in your Vinyl Express Plotter, the pinch rollers may not be correctly positioned over the grit rollers. Check the position of the pinch rollers and adjust them accordingly.
Why are characters deformed when pen plotting on my Vinyl Express Q60?
If characters or lines are deformed during pen plotting with your Vinyl Express Plotter, the plotter might be in cutting mode. Set the blade type on the CUTTER OFFSET function to PEN (0).
What to do if media comes loose from pinch roller on Vinyl Express Q60?
If one side of the media comes loose from the pinch roller on your Vinyl Express Plotter, the front or rear edge of the media might not be cut straight. Ensure the media edge is cut straight.
How to unlock pen settings on Vinyl Express Plotter?
If your Vinyl Express Plotter's pen settings cannot be changed, DATA SORTING is likely enabled. Disable DATA SORTING to regain control over the pen settings.
Why did the pen settings change on my Vinyl Express Q60 Plotter?
If the pen settings on your Vinyl Express Plotter have changed unexpectedly, the parameter priority setting may be set to program mode. Change the parameter priority setting to manual mode.
General| Brand | Vinyl Express |
|---|---|
| Model | Q60 |
| Category | Plotter |
| Language | English |
To Next Page