Place the brush or the pad-holder under the
deck and Lower the deck or the brush/ pad
holder by pressing the pedal. The squeegee
is raised and lowered with the deck.
Press one of the safety-switch levers on the
handle to engage the brush/pad-holder,
then release it.
Press solution and vacuum buttons on and
start cleaning by placing the hands on the
safety switches.
Use and maintenance
Operating guidelines AS4335C
July 2020
Remove the red cover, ll the tank with
clean water and use maximum temperature
40 degree. Add appropriate low foaming
detergent according to dosage information.
Check the level of water with the red ball
on the left side of the machine.
Connect the power supply plug to the
electrical mains and press machine ON
button.
Lift the deck by pressing the pedal.
Solution ow can be adjusted according to
the scrubbing need
Lift the squeegee up by hand until it locks in
up position and turn suction off for double
scrubbing.
To go back to working mode, use the red
lever to release the squeegee and turn
suction on again.
When scrubbing is complete, turn off
the machine to perform the following
maintenance.
To Next Page
Need help?
General
