To Next Page
A
Anthony JacksonAug 12, 2025
What to do if recovery water vacuuming is insufficient on my Viper Cleaning Equipment?
- BBrandi MitchellAug 13, 2025
If the recovery water vacuuming is insufficient in your Viper Cleaning Equipment, several factors could be at play. The recovery water tank might be full, in which case you should empty it. The hose could be disconnected from the squeegee, so ensure it's properly connected. Check if the vacuum grid is clogged or the float is stuck closed; if so, clean the grid or check the float. The squeegee might be dirty, or the blades could be worn or damaged, requiring cleaning and inspection. Also, verify that the tank cover is correctly closed, the gasket isn't damaged (replace if needed), and the bend tube isn't clogged (clean if necessary). Finally, a dirty recovery water tank can also cause this issue, so make sure to clean it.
General