Why is my Viper Swimming Pool Vacuum running on its side?
If your Viper Swimming Pool Vacuum is running on its side, this may be due to heavy debris. Make sure you empty the bag. It could also be because the hose floats are not correctly placed; in that case, refer to "Sizing Pressure Hose".
What to do if there is little or no sweep hose movement in my Viper Hayward 5500 Swimming Pool Vacuum?
If the sweep hose of your Viper Swimming Pool Vacuum has little or no movement, it could be because the sweep hose is too weak. In this case, increase the sweep hose power. Alternatively, there might be a hole in the sweep hose, requiring you to replace it with P/N AX5000RSHA.
Why does the hose on my Viper Swimming Pool Vacuum frequently tangle?
If the hose of your Viper Swimming Pool Vacuum frequently tangles, ensure the floats are evenly spaced. There should be one float 18" inches from each end, and a third float in the middle, 5 feet from either end. Also, the hose might be too long, so check the hose length. The spin-out could also be too long or too frequent, so check the Summer/Winter position of the cam and consider using a spin-out cam with fewer prongs.
What to do if my Viper Swimming Pool Vacuum cleaner does not reach the furthest point in the pool?
If your Viper Swimming Pool Vacuum cleaner does not reach the furthest point in the pool, it might be because the hose is too short. Check the hose length to ensure it is adequate.
How to stop my Viper Hayward 5500 sweep hose from spraying out of the pool?
If the sweep hose sprays out of the pool when using your Viper Swimming Pool Vacuum, it is likely that the sweep hose is too strong. You should reduce the sweep hose power.
What to do if my Viper Swimming Pool Vacuum cleaner head cannot escape from some corners?
If the cleaner head of your Viper Swimming Pool Vacuum cannot escape from some corners, it could be that the spin-out is too short. Try changing the cam to the Winter position.
Why does the cleaner head rotate more than 3/4 turn during spin-out on my Viper Hayward 5500 Swimming Pool Vacuum?
If the cleaner head rotates more than 3/4 turn during spin-out with your Viper Swimming Pool Vacuum, it means the spin-out is too long. Change the cam to the Summer position.
How to fix slow or no forward movement in my Viper Swimming Pool Vacuum?
If your Viper Swimming Pool Vacuum has slow or no forward movement, it could be due to low or no water pressure. Check the filtration and booster pumps, valves, and cleaner connections. Also, check the cleaner pressure.
What to do if my Viper Hayward 5500 Swimming Pool Vacuum has no spin-out?
If your Viper Swimming Pool Vacuum has no spin-out, it could be because the cam is not properly installed. Open the cam cap and check that the cam and thumbscrew are properly installed, then close the cam door.
Details risks and necessary precautions related to electrical shock.
Covers safety warnings for severe injury, death, or property damage.
Advises on preventing damage to the cleaner and associated pool equipment.
Step-by-step instructions for properly installing the universal wall fitting.
Guidance on how to securely connect the cleaner's hose to the wall fitting.
Detailed steps to set the correct operating pressure for optimal cleaner performance.
How to change the frequency of the cleaner's spin-out action for better coverage.
General| Brand | Viper |
|---|---|
| Model | Hayward 5500 |
| Category | Swimming Pool Vacuum |
| Language | English |
To Next Page