Virax 2402 - Page 14

14
EN
Manual hydraulic bender 2402/1
with hydraulic cylinder No.1
Existing compositions to bend medium series and strong series tubes.
Compositions delivered with 5 forms from 3/8” to 1”1/4 referenced 240141 to 240145 (see table page 16).
Components
240233
Options available
Manual cylinder No.1
240201
•
Forms from 3/8” to 1” to bend light series tubes (see table
page 16)
Pumping lever
240200
•
Sliding flanges
240211
•
Forms from 12 mm to 25 mm to bend locksmith tubes (see
table page 16)
FC roller (x1)
240111
••
Case 652 x 350 x 295 mm
240126
•
Manual 2402/2 and electric 2408/2 hydraulic benders
with hydraulic cylinder No.2
Existing compositions to bend medium series and strong series tubes.
Compositions delivered with 7 forms from 3/8” to 2” referenced 240141 to 240147 (see table page 16).
Components
240242
240243
240842
240843
Manual cylinder No.2
240202
•
•
Pumping lever
240200
•
•
Cylinder No.2 - 230V monophase
240802
•
•
Open flange
240216
•
•
FO roller (x1)
240114
••
••
Sliding flanges
240217
•
•
FC roller (x1)
240115
••
••
Manual bender case 800 x 395 x 295 mm
240127
•
•
Electric bender case 870 x 362 x 434 mm
240186
•
•
Options available:
- Forms from 3/8” to 1”1/2 for light series tubes (see table page 16)
- Forms from 12 mm to 50 mm for locksmith tubes (see table page 16).
- Forms of 40, 50, 63 mm and rollers for multilayer tubes, only with sliding flanges (see table page 16).
- Run limiter for electric cylinder 240811
- Low base tripod for open flange 240103
- Wide base tripod for open flange 240107
- Tripod for sliding flanges 240105
- Bending complement for tubes from 2”1/2 to 4” 240248