Need help?Do you have a question about the VIRDI AC-2100 Plus and is the answer not in the manual?
General| Device Type | IP Access Controller |
|---|---|
| Fingerprint Sensor | Optical Sensor |
| FAR | ≤ 0.001% |
| FRR | ≤ 0.1% |
| Fingerprint Capacity | 10, 000 |
| Card Capacity | 10, 000 |
| Log Capacity | 100, 000 |
| Transaction Capacity | 100, 000 |
| Max Events | 100, 000 |
| Operating Voltage | 12V DC |
| Fingerprint Verification Time | ≤ 1 second |
| RF Card | Mifare, EM |
| Communication | TCP/IP, RS-485 |
| Communication Interface | Ethernet |
| Input | Door Sensor |
| Output | Relay, Buzzer |
| Operating Temperature | -20°C to 60°C |
| Humidity | 20% to 80% RH |
Verifies fingerprint against a specific user ID or card.
Identifies user solely by fingerprint among registered ones.
Critical warnings and cautions for safe operation and terminal care.
Explains the functions of F1, F2, F3, and F4 buttons in various modes.
Provides instructions on how to correctly register and input fingerprints.
Covers checkpoints before initial setup, including entering the menu and saving changes.
Details operations for adding, deleting, and modifying users and administrators.
Guides through setting up terminal ID, IP addresses, and server connections.
Configures 1:1 and 1:N authentication levels for fingerprint matching.
Guides on using the terminal for access control with various authentication methods.
Explains attendance and time tracking functions using fingerprint or card.
To Next Page