Viro VR 550E User Manual

1 2
3 4
5 6
Use the included large Allen wrench to loosen the bolts from
the bottom of the handlebar. Use the included small Allen
wrench to loosen the bolt on the front of the handlebar.
Use scissors (not included) to carefully remove the zip ties
that attach the cables to the handlebar. Do not cut the brake
cable or electronic wire.
Use an Allen wrench to remove the screw from the brake.
Push up rmly on the brake to remove the handlebar grip
and slide the brake o of the handlebar.
Remove the handlebar.
Use an Allen wrench to remove the screw from the throttle.
VR 550E
ELECTRIC SCOOTER
NOTE: BEFORE BEGINNING, ENSURE THE UNIT IS TURNED OFF.
IMPORTANT: An ADULT must make all repairs. Thoroughly inspect all parts after making modications. DO NOT RIDE until
you are sure the proper repairs have been made and the unit is assembled according to the manufacturer’s specications.
If you are unsure of any repairs, contact consumer service.

Viro VR 550E Specifications

General

Brand	Viro
Model	VR 550E
Category	Scooter
Language	English

Summary

VR 550E Electric Scooter Operations

Safety and Preparation Notes

Important safety warnings, adult supervision, and ensuring the unit is turned off before starting any repairs or modifications.

Handlebar Component Removal

Instructions on how to loosen bolts, remove zip ties, and detach brake and throttle components from the handlebar.

Handlebar Reassembly and Adjustment

Guide to installing new handlebar grips, throttle, brake, securing cables, and final adjustment of components.