EasyManua.ls Logo

Virtue Audio one - Page 10

Virtue Audio one
11 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
We make audio lovers audiophiles.
TM
Better Sound by Design.
TM
Virtue ONE & TWO Owner’s Manual
http://www.virtueaudio.com Page 10 of 11
between 10 and 20 times. If the switch remains non-functional, please contact us about
replacing the switch.
Issue:
Issue:Issue:
Issue: FM recep
FM recep FM recep
FM reception is weaker when the radio is beside the amplifier
tion is weaker when the radio is beside the amplifiertion is weaker when the radio is beside the amplifier
tion is weaker when the radio is beside the amplifier
Recommendation:
Recommendation:Recommendation:
Recommendation: Please try moving the unit at least 24 inches away from FM receiver in
order to reduce interference.
Issue:
Issue:Issue:
Issue: The left and right RCA jacks are reversed
The left and right RCA jacks are reversed The left and right RCA jacks are reversed
The left and right RCA jacks are reversed
Recommendation:
Recommendation:Recommendation:
Recommendation: Due to a silkscreen printing error, input RCA jacks are not labeled “Left”
and “Right” as they are with the output speaker posts. You should find in all cases that the
black input jack corresponds to the “Right” channel and the red input jack corresponds to
the “Left” input source channel. Phase is correct on the amplifier.
Issue:
Issue:Issue:
Issue: The Virtue label fell off
The Virtue label fell off The Virtue label fell off
The Virtue label fell off
Recommendation:
Recommendation:Recommendation:
Recommendation: Due to some very cold weather this
winter in both shipping and storage, your “VIRTUE” label
on the front of the amp may have come unglued. A drop
of Super Glue will fix it back in place.
Issue:
Issue:Issue:
Issue: The red light behind the volume knob is flashing often
The red light behind the volume knob is flashing often The red light behind the volume knob is flashing often
The red light behind the volume knob is flashing often
Recommendation:
Recommendation:Recommendation:
Recommendation: Seeing this light during play indicates clipping, a condition when the
peaks of the signal are clipped off. This is the power limit of the amp. If you find your unit
clipping often, please consider upgrading the power supply or turning down the volume.
Both the ONE and TWO amplifiers will play more than 90wpc cleanly at 30v with sufficient
current. The unit will drive loads as low as 2 ohms and with speakers as insensitive as
83db, we have many satisfied customers.
Issue:
Issue:Issue:
Issue: My propeller posts have broken free from the chasis
My propeller posts have broken free from the chasis My propeller posts have broken free from the chasis
My propeller posts have broken free from the chasis
Recommendation:
Recommendation:Recommendation:
Recommendation: It is possible to over-tighten the posts, thereby breaking allowing them to
freely rotate. If this occurs, please open up the enclosure and tighten down the posts from
the inside. Also, add some super-glue or Lok-Tite™ to reduce the chance of untwisting.