We make audio lovers audiophiles.
TM
Better Sound by Design.
TM
Virtue ONE & TWO Owner’s Manual
http://www.virtueaudio.com Page 4 of 11
Setting up your amplifier
We bubble wrap several of the amplifier parts to protect them during long-distance shipping. After
unwrapping the parts, you should be up and running within 5 minutes. You will then need to:
1) Attach the volume knob
2) Connect the signal and speaker cables
3) Plug in power
4) Turn on!
Attach the volume knob
Attach the volume knobAttach the volume knob
Attach the volume knob
After unwrapping the amplifier and the volume knob, you must
attach the volume knob, which is shipped separately to minimize
possible damage to the POT/attenuator. The volume knob will
not always be tight enough to avoid dropping off. We
recommend putting a drop of super-glue into the inner plastic
bushing and then immediately pressing on the knob. The flat
part on the bushing should correspond with the flat part of the
POT/attenuator shaft.
To Next Page
Loading...