12 13
AFTER SALES SUPPORT
YEAR WARRANTY
1
MODEL: AP180320 PRODUCT CODE: 10714 08/2019
customercare@winplus.com.au1300 663 907
AUS
AFTER SALES SUPPORT
YEAR WARRANTY
1
MODEL: AP180320 PRODUCT CODE: 10714 08/2019
customercare@winplus.com.au1300 663 907
AUS
Getting Started
Cleaning & Maintenance
Step 2 – Back & Side of the Head
• With the 10mm or 13mm guide comb, cut the hair at the back of the head
Step 3 – Side of the Head
• With the 10mm or 13mm guide comb, trim sideburns
• Then change to the longer 22mm guide comb and continue to cut the top of the head
Step 4 – Top of the Head
• Using the 25mm guide comb, cut the hair on the top of the head against the direction in
which the hair normally grows
• For longer hair, use the scissors provided. Lift the hair on the top of the head with your
ngers & cut to the desired length
• Always work from the back of the head
Step 5 – To Finish
• Use the Hair Clippers without any attachment comb for close trimming around the base and
sides of the beck
• To produce a clean straight line at the sideburns, reverse the clipper. Place the Hair Clippers
at right angles to the head, tips of the blade lightly touching the skin and work downwards
• Hold the Hair Clipper to the front of your hair with the blades pointing towards the back of
your head and move the Hair Clipper towards your crown. Repeat as necessary, moving in
rows from the front and the sides of your head to the back
• You should achieve an even length cut all over your head
Outlining
• To tidy up the edges around your cut e.g. neckline and sideburns, detach the attachment comb
• Hold the appliance upside down, so the front of the Hair Clipper is facing towards your head
• Hold the Hair Clipper straight on your sideburns or neckline and move the Hair Clipper
downwards. This will give you a clean, smooth nish
Storage
• When not in use, unplug the appliance and store out of reach of children in a safe, dry
location. Never wrap the cord around the appliance as this will cause the cord to wear
prematurely and break. Handle the cord carefully, and avoid jerking, twisting or straining
especially at plug connections
Before cleaning the Hair Clippers ensure it is turned off and unplugged from the power outlet.
CAUTION: KEEP THE APPLIANCE AND THE ADAPTOR DRY. ONLY CLEAN
THE APPLIANCE AND THE ADAPTOR WITH THE CLEANING BRUSH
SUPPLIED. NEVER USE COMPRESSED AIR, SCOURING PADS, ABRASIVE
CLEANING AGENTS OR AGGRESSIVE LIQUIDS SUCH AS ALCOHOL, PETROL
OR ACETONE TO CLEAN THE APPLIANCE. DO NOT USE ANY SHARP
OBJECTS TO CLEAN THE APPLIANCE.
To maintain optimum performance, the appliance should be cleaned after each use:
• Remove the attachment comb - the attachment combs can be rinsed under water.
Please ensure comb’s surface are dried thoroughly before storage or further use.
• Using the cleaning brush, brush and blow away any remaining hair from the blades and from
the neck
• Do not disassemble the blades or the Hair Clipper
• Clean the appliance after every use
At the end of its working life, do not throw this product out with your household rubbish.
Electrical and electronic products contain substances that can have a detrimental effect on the
environment and human health if disposed of inappropriately. Observe any local regulations
regarding the disposal of electrical consumer goods and dispose of it appropriately for
recycling. Contact your local authorities for advice on recycling facilities in your area.
Please keep the original packaging carton and materials in a safe place. It will help to prevent
any damage if the product needs to be transported in the future. In the event it is to be disposed
of, please recycle all packaging material where possible.
If you require another copy of this instruction manual, please contact
customercare@winplus.com.au to obtain an electronic copy.
Disposal
To Next Page
Loading...
