To Next Page
A
Alicia LuceroAug 9, 2025
Why is my ViscoTec Water Pump not feeding material properly?
- AAdam WatkinsAug 9, 2025
If your ViscoTec Water Pump is not feeding material adequately, several factors could be at play. First, ensure the motor is properly connected. Then, verify the electrical installation for any faults in the mains supply. If the material has hardened, you'll need to dismantle and clean the dispenser. Also, check for a blocked dosing needle and clean or replace it as needed. If the needle is too small or long, switch to a different cross-section and reduce the speed or flow rate. Other potential issues include a worn stator/rotor (replace them), a swollen stator (check its material resistance and replace if necessary), an incorrect revolution (correct it), or an inadequate material supply (feed material, check inlet pressure, and adjust accordingly).
General