vision microsystems VM1000 - Page 41

42
SECTION
2 OPERATION
SETTING LOCAL TIME:
STEP 1: With
power
on,
place
the selector
switch
in the
'straight
up'
position
(between
the'RUN'
and'STOP'
positions).
The display
\:
should
go
blank.
STEP
2:
Turn the
power
off for
a few seconds,
then
back
on. The
display
will now alternately
show
'Utc
?' and'Loc
?'.
STEP 3: When
the display
shows'Loc
?', move
the selector
switch
to the
'HRS'
position.
When
the hours
value
gets
to
the correct
hour, move
the switch
to the'straight
up'position
as before.
The display
will read
'Locrdy'. Wait for
this
message
to
disappear,
then move
the
selector
to any desired
position.
(You
can now check
'LOC'
for
the
correct local
time).
NOTE:
Since
universal and local
minutes
and seconds
are the same,
you
can
only set local
hours.
50IIII}02
REV
F
VMIII(}O
OWNERS
MANUAL