vision microsystems VM1000 - Page 42

SECTION
2
OPERATION
43
2.9.2
CHRONOMETER
NORMAL
OPERATION:
'RUN'
TIMER
Move
the
selector
to the
'RUN'
position.
The display
will count
up in
seconds/minute
and
hours, if
no
preset
countdown
time was loaded,
just
as a
stopwatch
would.
If
a countdown
time
was
loaded,
then
the
display
will
count
down in
hours,
minutes
and
seconds.
A
graphic
pattern
is also displayed
during
countdown.
See
section
on
'Stopwatch
Operation'.
'UTC'
UNIVERSAL
TIME COORDINATED
Simply
move
the selector
to the
'UTC'
position.
The
display
will
show
universal
time
in
hours, minutes
and seconds.
A
distinct
graphic
pattern
is
also
displayed
to
indicate
that
the
'time'
mode
is
active.
.._.
'LOC'
LOCAL
TIME
Move
the selector
to the
'LOC'
position.
The
display
will show
local
time
in hours,
minutes
and seconds.
A
distinc{
graphic
pattern
is also
displayed
to indicate
that one of
the two
'time'
modes is active.
'FLT'
FLIGHT
TIMER
Move
the
selector
to
the
'FLT'
position.
The
display
will
show
the
total
time in
hours, minutes
and
seconds
since
the
system
was last
'powered-up'.
This
is useful
for
your
log book
entries
and in-flight
time
keeping.
Be
sure to
note
the
'FLT'
time before shutting
off
the master
as
it
is cleared
at
next
'power-up'.
5010002
REv F
VMTOOI}
OWNERS
IIANUAL