vision microsystems VM1000 - Indicator and Display Cable Installation

SECTION
I INSTAI,[,A'T'ION
1.0.3 INDICATOR
MOUNTING
&
WIRING
The
indicator
is
mounted
to the
panel
from
the
back side.
Four
mounting
screws
are
provided
for
this
purpose.
Do
not
use
longer
screws
or damage
to
the
instrument
will result.
The
supplied screws
will accommodate
panel
thicknesses
from 0.062
to
0.050 inches.
lf
a
panel
thickness
of other
than this
is
required,
then
determine the
difference
in
thickness
and
procure
new screw
length
accordingly.
Test
your
new screw
lengths
by
finger tightening
them
into the
panel
and indicator.
The screws
should
tighten
against
the
panel
only and
should
not
'bottom
out'
in
the
indicator.
Be
careful
not to cross
thread
the
screws or the
indicator bezel
will
be
permanently
damaged.
The
indicator cut-out
and mounting
space
requirement's
information is
provided
in
'SECTION
5 ILLUSTRATIONS'.
To wire indicators to DPU
simply
plug
any display
cable connector
into
the back
of
the
indicator
observing
the keying
tab to notch.
1.0.4
DISPLAY
CABLE
FABRICATION
(P/N
401000s)
STEP 1: Carefully
move the
connectors
into the
positions
required
on
the flat. ribbon
cable for
your
panel
layout.
They may
face
either
up or down.
Look
for the small
embossed
arrowhead
on
the cable
connectors
that
points
to an
edge
of the cable.
MAKE SURE
ALL
CONNECTOR
ARROWHEADS
POINT
TO
THE SAME EDGE
OF
THE
CABLE
AS
THE
INSTALLED DPU
CABLE CONNECTOR
I
STEP 2: The
connector
is secured
to
the
ribbon
cable by closing
it
in
clean smooth
jaws
of a vise until
ine sides
'snap
over'
into
position.
Make sure
the
cable connector
is
SQUARE
TO
THE
CABLE before
any
closing
takes
place.
Once
installed,
connectors
and cable
cannot
be
re-used
!
STEP 3:
Once all
connectors
are
installed,
trim
any
excess cable
away by using a
new
SHARP
pair
of
scissors.
lnspect
the
cut
to
insure
that adjacent
wires
are
not
touching
each
other.
INSURE that once
installed,
the
trimmed
ends of
the
cable do not
touch anything.
50lr)002
REv
F
VM IIIIIII
OWNERS
MANUAL