vision microsystems VM1000 - Mode Switch Installation

SECTION
I INSTALLATION
1.0.5
MODE
SWITCH INST.
(P/N
3010023)
The
mode selector switch assembly can be mounted
anywhere within
reach
of
the indicator connector.
STEP 1: Once the
switch
hole has been located and drilled,
remove
the
paper
backing
and vinyl
front
covering
from
the
switch
plate.
The switch
plate
has an adhesive
backing
to aid
in
placement
of the
plate.
Press the
plate
into
position.
STEP 2: Rotate the switch shaft
as
far counter-clockwise
as it
will
travel
(as
viewed
facing the shaft).
The switch
comes with the
lock washer
and nut loosely installed.
When
removing
the
nut,
DO NOT
remove the silver
ring underneath. lf
you
have
accidentally moved the
silver
ring, it should be
placed
back
onto the switch
with
the
tab inserted
into
the hole between
switch
position
numbers
'9'
and
'10'.
This tab
acts
as a stop to
only allow
9
possible
switch
positions.
STEP 3:
lnsert
the
switch
assembly
(switch,
silver
ring
and
lock
washer) through
the back
of the
panel.
Place the
nut on the
switch
and
finger tighten.
Place the knob over the
shaft
such
that one of the
two set
screws is
perpendicular
to the
'flat'
on
the shaft.
Tighten
this set screw. Now
rotate
the entire switch
assembly
until
the
slotted
line on
the knob is aligned
with the
left
lower
white
line
on
the
switch
plate.
STEP 4: lf necessary,
carefully
remove
the
knob
without disturbing
the
current switch assembly
location. Now CAREFULLY
tighten the nut
(too
much
force
will
break the switch) .
lf
necessary, reinstall the
knob
as before and
tighten both set
screws.
Verify
correct alignment with
all
switch
plate positions.
Plug the switch
assembly
connector into the small connector
on the
appropriate
indicator.
5010002
REv F
VMIOOO
OWNERS
MANUAL