Metron Front Hydration System Installation Instructions
Published – Jul, 2017. ZS182B.v2 © Full Speed Ahead
Introduction
Congratulations on your Vision product. Please read these instructions and follow them for correct use. Failure to follow the
warnings and instructions could result in damage to product not covered under warranty, damage to bicycle; or cause an accident
resulting in injury or death. Since specific tools and experience are necessary for proper installation, it is recommended that the
product be installed by a qualified bicycle technician. FSA & Vision assumes no responsibility for damages or injury related to
improperly installed components.
Warranty
Full Speed Ahead (FSA) warrants all FSA, Vision, Metropolis and RPM products to be free from defects in materials or workmanship
for a period of two years after original purchase unless otherwise stated in the full warranty policy. The warranty is non-transferable
and valid to the original purchaser of the product only. Any attempt to modify the product in any way such as drilling, grinding, and
painting will void the warranty. For more information on warranty policy and instructions for completing a warranty claim, check out
the Full Warranty Policy found at our website: http://www.visiontechusa.com/support/warranty-policy/
Specification
Item Number / Model Name V0132 / Metron Front Hydration System
Components
Follow the assembly order in the illustration:
Hydration Extension Mountation①
Bento Attachment②
Aero Bottle③
Straw Seal④
Flex Straw⑤
Filler Port Seal⑥
Filler Port Labryinth Spout⑦
Filler Port Labryinth Maze⑧ -Lower
Filler Port Labryinth Maze⑨ -Upper
Filler Port Cap⑩ -Standard
Filler Port Cap⑪ -Garmin (TM)
Filler Port Cap⑫ -Computer
Antisplash Lid⑬
Port Screws⑭
Hydration Extension Mount Installation:
Over- Bar Mounting
1. Ensure the open end of the mount is facing forward. Snap one side of Hydration Extension Mount ① to one aero
extension (Fig. 1).
Note: See Fig. 1a for under-bar mounting position.
2. Rotate mount in to position and snap the other side on to the second aero extension.
3. Slide hook-and-loop straps through strap channels (Fig. 2) and pull securely.
4. Fold hook-and-loop straps back on themselves and press to adhere (Fig. 3).
5. Tighten the bolts to 30 kgf.cm / 3 Nm / 26 in.lbs (Fig.3a).
To Next Page
Need help?
General
