INSTALLATION
1. CONNECT INPUT
Plug HDMI cable into input.
Input and output cables are not included with this product.
2. CONNECT OUTPUTS
This product features pre-emphasis and equalization to overcome cable deficiencies. This
may not always be successful if poor quality cable is used.
3. TURN POWER ON
With the switch off at the wall, connect power adaptor then turn on. Source and display
devices can be turned on before they are connected.
It is not essential to do the steps in this order but it helps EDID handshake. If it is still not
working check the status lights to see if they are connected, and try cycling power.
NOTE: This product can be cascaded
To Next Page
Loading...