OPERATING THE POWERMASTER SYSTEM
D-303223 PowerMaster-10 / PowerMaster-30 User's Guide 13
Note: When forced arming is carried out, the buzzer “protests” by emitting a continuous tone during the exit
delay until the last 10 seconds of the delay. You can silence this signal by pressing the arming button again.
If forced arming is enabled and you wish to arm the system when NOT READY is displayed, proceed as shown:
PRESS RESULTING DISPLAY
ENTER CODE _ _ _ _
[Enter code]
Code
ARMING AWAY
PLEASE EXIT NOW
(to mute the buzzer)
Vacate the premises
↓ (Exit delay)
↓
AWAY
ARM indicator lights during the armed state.
Remember: Forced arming compromises security!!
Forced arming “HOME” is performed in a similar manner, as follows:
PRESS RESULTING DISPLAY
ENTER CODE _ _ _ _
[Enter code]
Code
ARMING HOME
PLEASE EXIT NOW
(to mute the buzzer)
Go to interior zone
↓ (Exit delay)
↓
HOME HH:MM
ARM indicator flashes during the armed state.
Arming in the Latchkey Mode
This mode, if enabled by the installer, is useful for a parent at work who wants to be sure that his children have
returned from school and have disarmed the system. A special “latchkey” message will be sent out when the
system is disarmed by a “latchkey user”.
Latchkey users are holders of user codes 5 through 8 (PowerMaster-10) / user codes 23-32 (PowerMaster-30)
or users of Keyfob transmitters 5 through 8 (PowerMaster-10) / 23-32 (PowerMaster-30). The latchkey message
is considered an alert and not an alarm, and is therefore sent to the private telephones programmed by the user
as targets for alert messages.
Latchkey arming is possible only when you arm “AWAY”. To arm in the Latchkey mode, proceed as follows:
PRESS RESULTING DISPLAY
ARMING AWAY
To Next Page
Loading...
