EVENT REPORTING & CONTROL BY TELEPHONE AND SMS
D-303223 PowerMaster-10 / PowerMaster-30 User's Guide 53
To connect to the PowerMaster-10 / PowerMaster-30 via GSM:
1. Dial the PowerMaster-10 / PowerMaster-30 GSM tel. No.
2. Wait for 2-4 rings then hang up.
1
3. Wait 12-30 sec.
4. Redial PowerMaster-10 / PowerMaster-30 GSM tel. No.
5.
[User code], [#]
2
6. [Desired command, see next table]
3
Notes:
(1) Alternative to steps 2 – 4: The PowerMaster-10 / PowerMaster-30 responds in a similar way if you just dial
once and wait until you hear telephone rings (in USA, for example, 11 rings).
(2) Entering of user code is required once only.
(3) If you wait more that 50 seconds (may change according to setup / use) without keying a command, the
PowerMaster-10 / PowerMaster-30 will disconnect the line.
B. Executable Commands
Command Single Partition Keying
Sequence / PowerMaster-10
All Partitions Keying
Sequence (PowerMaster-30)
To Next Page
Loading...
