MOC.TOPEDEMOH
.ecnatsissa rehtruf rof 3130-725-778-1 tcatnoc esaelP
4
Pre-installation
PLANNING INSTALLATION
□ The refrigerator should be located on a completely flat surface.
□ Leave about 2 to 4 inches (5-10 cm) between each side of the appliance and the wall.
□ Leave 12 inches (30 cm) between the top of the appliance and the ceiling.
□ Choose a location which is not exposed to sunlight, high temperature or humid, as humidity may cause stain.
□ The appliance can be adjusted by turning its two legs in the front of the bottom panel when it is unstable. Turning them in the
clockwise direction can raise the refrigerator.
□ The location should be firm and flat. An unsecure position may cause noise and vibration. The noise may be increased if the floor is not
firm. Put a sheet under the appliance to solve the heat emission if you need to locate it onto a carpet.
□ Make sure the adjustable legs are firm on the floor, an
d set the appliance slope backward slightly to keep the doors closed tightly.
□ Make note of the position of the contents and retain packaging for future packing and moving.
□ Do not lift by the door handle when moving the appliance.
□ Do not tilt the appliance more than 45 degrees.
□ Avoid strong vibration and collision.
TOOLS REQUIRED
Medium-sized Phillips
screwdriver
Small-sized Flat - head
screwdriver
llen wrench