Visslo F8 premier - Page 41

* Chamfer Width <BVL, F>, <BVL, R> : Compensate width
* Chamfer Width <FLT, F>, <FLT, R> :Compensate width
6) Regulate Axis : Necessary compensation value for regulating angle of axis
--> Groove Wheel Axis Compensation 0 <--
Chamfer <F> Axis Compensation 0
Chamfer <R> Axis Compensation 0
Finish Wheel Axis Compensation 0
Polish Wheel Axis Compensation 0
Feeler <F> Axis Compensation 0
Feeler <R> Axis Compensation 0
Calibration Axis Compensation -500
Exit
* Groove Wheel Axis Compensation :
* Chamfer <F>, <R> Axis Compensation :
* Finish Wheel Axis Compensation :
* Polish Wheel Axis Compensation :
* Feeler <F>, <R> Axis Compensation :
* Calibration Axis Compensation :
7) Wheel Dressing : Whell dressing mode
* Water Feeding ON/OFF : Confirm pump is working
* Wheel Dressing ON/OFF : Confirm wheel is working
* Groove Wheel ON/OFF : Confirm wheels of groove and chamfer
* Movement Inspection : Contact Sensor Check
gauge encoder values check
head chuck pressure check
******* Regulate Axis *******
Water Feed ON/OFF
Wheel Dress ON/OFF
Groove Wheel ON/OFF
Movement Inspection
Exit
***** Wheel Dressing & Test *****
--
----
-->
>>
>
<--