Now there are two possibilities:
1) select "Activate Volume"
This will activate the RAID array and will find all devices connected to
it. This will also make the secundairy disk the primary.
2) select "Delete Volume"
This makes the RAID-controller an ordinary SAS disk controller. Thus the
next time the computer boots, the computer boots from the first disk it
finds connected to this controller.
Select "Activate Volume"
Screen6 appears:
╔═════════════════════════════════════════════════════════════════════Screen6══╗
║ LSI Corp Config Utility v7.23.02.00 (2011.11.23) ║
║ Manage Volume – SAS2308-1 ║
║ ║
║ ║
║ Y Activate volume and exit this menu ║
║ ║
║ N Abandon volume activation and exit this menu ║
║ ║
║ ║
║ Esc = Exit Menu F1/Shift+1 = Help ║
║ Enter=Select Item ║
╚══════════════════════════════════════════════════════════════════════════════╝
Press "Y" to activate the array again
Exit the configuration setup utility and boot the computer again.
To Next Page
Loading...